Mustang Parts › BBK Cold Air Intake Installation Instructions (2005+ V6)
Share

BBK Cold Air Intake Installation Guide (2005-2010 V6)

This Mustang Parts Installation Guide Works For

BBK Cold Air Intake (05-10 V6)BBK Cold Air Intake (05-10 V6) 1737
Fitment Includes:
  • - V6 2005, 2006, 2007, 2008, 2009, 2010
DOWNLOAD PDF

Tools Required

  • Small screwdriver
  • 1/4" ratchet
  • 8mm and 10mm sockets
  • 2.5mm Allen wrench
  • T-20 Torx
Installation Time: 60 Mins

Installation

  1. image 01
    Stock Factory Air Intake
  2. Disconnect negative terminal on your battery.
  3. Disconnect Mass Air Flow (MAF) harness. Pull the red clip up and pull outward from the assembly.
  4. Disconnect Vacuum (PCV) Hose. Push the slip over the little notch and pull the house off.
  5. Remove the bolt holding the Air filter housing, and loosen the clamp near the throttle body.
    image 02
  6. Remove the intake assembly and set aside.
  7. Remove the radiator shroud. Use a flathead screwdriver to pry the pin up, and then remove the pin assembly. (mines silver)
  8. With the shroud removed, remove the upper radiator support. remove the bolt closest to the grill, and then work the piece off.
    image 03
  9. Put the blue filter coupler on the throttle body and slip a steel band over and tighten(the piece has a grove in it for the band to fit into)
  10. Remove the MAF assembly from the original intake and transfer it to the new BBK intake piping.
    image 04
  11. Put the black shroud over the new intake pipe and install the new air filter. Slide it on until it meets the MAF assembly.
  12. Put the shroud insulation over the shroud. i cut it in the middle so it would go around the 90 degree bend easier.
  13. Put the radiator support and shroud back on.
  14. Reconnect the MAF harness and PCV Line.
  15. Reconnect your negative battery terminal.
    image 05
    Finished Installation
  16. Start the car and listen for any air or vacuum leaks, a vacuum leak could cause the check engine light to come on. If your check engine light does come on double check all your connections and make sure they are tight. A nice feature of the BBK CAI is that it doesnotrequire a computer retune for use on the 2005+ V6 Mustangs like other brands do.
  17. Now just admire the good looks and extra horsepower your new BBK cold air intake has to offer.

Installation instructions provided by AmericanMuscle customer Kuro Tawil