Airaid Poweraid Throttle Body Spacer (2011 V6) - Installation Instructions

This Mustang Parts Installation Guide Works For

Airaid Poweraid Throttle Body Spacer (11-13 V6)DOWNLOAD PDF

Tools Required

  • 8mm Socket
  • 10mm Socket
  • Ratchet & Extension
  • Pliers
Installation Time: 60 Mins

Installation

  1. Disconnect the breather line or lines, from the Factory intake tube. Loosen the clamps securing the intake tube to the throttle body and airbox. Remove the factory intake tube and set it aside.

    Airaid Poweraid Throttle Body Spacer 2011 V6 1

  2. Using Pliers, open the spring clamps and slide off of the factory breather hose, and onto the hard line

    Airaid Poweraid Throttle Body Spacer 2011 V6 2

  3. Remove the four bolts that secure the throttle body to the intake and set it aside. They will not be reused.

    Airaid Poweraid Throttle Body Spacer 2011 V6 3

  4. Position the Poweraid Spacer between the throttle body and the intake manifold with the supplied gasket next to the throttle body as shown. Make sure the "flow" arrow that is printed on the spacer is pointing towards the intake manifold. Insert the provided bolts and washers through the throttle body, gasket and Poweraid Spacer.

    Airaid Poweraid Throttle Body Spacer 2011 V6 4

  5. Remove the factory breather hose and spring clamps, and replace them with the supplied Breather hose and Speed clamps. Retorque the throttle body bolts in an "X" pattern, to Factory specs.

    Airaid Poweraid Throttle Body Spacer 2011 V6 5

  6. Reinstall the intake tube, tighten the two hose clamps, and reconnect the breather line or lines. Reconnect the negative battery cable.

    Airaid Poweraid Throttle Body Spacer 2011 V6 6

Installation instructions provided by Manufacturer.