Mustang Parts › Install Guides, Tech Guides & Frequently Asked Questions › Mustang Installation Guides › How to Install an MMD Bolt On Hood Strut Kit on Your 1999-2004 Mustang
Share

How to Install an MMD Bolt On Hood Strut Kit on Your 1999-2004 Mustang

This Mustang Parts Installation Guide Works For

MMD Bolt On Hood Strut Kit - Black (99-04 All)MMD Bolt On Hood Strut Kit - Black (99-04 All)
Fitment Includes:
  • - V6 1999, 2000, 2001, 2002, 2003, 2004
  • - GT 1999, 2000, 2001, 2002, 2003, 2004
  • - Cobra 1999, 2001, 2003, 2004
  • - Mach 1 2003, 2004
  • - Bullitt 2001
MMD Bolt On Hood Strut Kit - Chrome (99-04 All)		DOWNLOAD PDF

Tools Required

  • Flat-Head Screwdriver
  • 3/8” Drive Ratchet w/extensions
  • 8mm & 10mm Sockets
Installation Time: 1 Hour

Installation

Step 1:

Prop hood open and remove the 8mm fender bolt as shown in photo (Do not remove the rear-most bolt for the hood hinge itself). Place the lower mounting bracket as shown and re-install the fender nut.

MMD-Bolt-On-Hood-Strut-Kit-Black

Step 2:

Use a 10mm socket to remove the forward most hood hinge nut. Loosen the rear hood hinge nut about 1/4” (enough to slide in the upper strut mounting bracket).

MMD-Bolt-On-Hood-Strut-Kit-Black

Step 3:

Slide the upper bracket between the rear-most nut and hood hinge and place it over the exposed front stud as shown. Once in place, tighten rear nut and re-install front nut.

MMD-Bolt-On-Hood-Strut-Kit-Black

Step 4:

Install the gas strut by simply popping the ends over the ball mounts on the brackets.

Repeat Steps 1-4 for opposite side strut assembly. You may remove the factory prop rod at this point. Be sure to close hood carefully after installation to ensure proper alignment of hood. If any adjustment is needed, the mounting holes in the strut brackets are slotted for easy alignment.