Mustang Billet Upper Grille (94-98) - Installation Instructions

This Mustang Parts Installation Guide Works For

Upper Grille Only - GT, V6 & CobraDOWNLOAD PDF

Tools Required

  • Small Socket and Wrench Set
  • Small Flathead Screwdriver
  • Small Phillips Screwdriver
  • Droplight or Other Portable Lighting Source (optional)
Installation Time: 30 Minutes

Installation

  1. Remove the radiator shroud. Release the clips holding the shroud in place.
  2. Mustang Upper Billet Grille No Pony 9498 1

  3. To remove the pony and its bracket, simply unscrew the 2 Phillips head screws that are holding it to the vehicle.
  4. Mustang Upper Billet Grille No Pony 9498 2

  5. Center your new grille in your hood opening, and have your assistant hold the grille while you mark the location of the 3 brackets: on top center, and 2 lower side brackets. (A metallic marker, nail polish, or a sharp scribe will all work.)
  6. Mustang Upper Billet Grille No Pony 9498 3

  7. Using a 3/16" bit, drill a pilot hole in each of the locations you marked above.
  8. Mustang Upper Billet Grille No Pony 9498 4

  9. Attach grille by using supplied hardware. Tighten using hand tools. DO NOT USE POWER TOOLS IN THIS STEP, as it may damage your Mustang's plastic grille shell. Also, make sure not to over-tighten your hardware.
    Note:If your Mustang was produced between 1/1/94 and 6/30/95, in order to prevent interference with the grille and insure easy opening of your hood, you may need to update your hood latch to the later style used in cars produced from7/1/95 through 11/30/98. This part can be obtained from your Ford dealership, using part #F6ZZ-16700-AA.
  10. You're finished. Enjoy your new billet grille from Stack Racing.
  11. Mustang Upper Billet Grille No Pony 9498 5

Installation instructions provided by Stack Racing

Continue Shopping