Mustang Parts › 2005-2009 Mustang Hood Scoop - Painted - Installation Instructions
Share

2005-2009 Mustang Hood Scoop - Painted - Installation Instructions

This Mustang Parts Installation Guide Works For

Hood Scoop - Pre-painted (05-09 All)Hood Scoop - Pre-painted (05-09 All)
Fitment Includes:
  • - V6 2005, 2006, 2007, 2008, 2009
  • - GT 2005, 2006, 2007, 2008, 2009
  • - Bullitt 2008, 2009
DOWNLOAD PDF

Tools Required

Basic Hand Tools Required
Installation Time: 60 Mins

Installation

  1. Cut windshield washer nozzle holes out of supplied template.

    Painted Hood Scoop 0509 1

  2. Place template on hood using washer nozzles for guidance.

    Painted Hood Scoop 0509 2

  3. Pull template as tight as possible and place tape on the corners to keep desired placement.

    Painted Hood Scoop 0509 3

  4. Open hood and using a small flat-bladed screwdriver remove plastic retaining clips keeping the hood insulation on. When all clips are removed, pull insulation from hood and set aside.

    Painted Hood Scoop 0509 4

    Painted Hood Scoop 0509 5

  5. Using a 7/32 drill bit, drill 7 holes through the “X” marks on the template. It is very important that the template has been properly applied and pulled tight as outlined in Steps 2 and 3. Once holes have been drilled, the tape and template can be removed from vehicle.

    Painted Hood Scoop 0509 6

  6. Using the supplied 3M Automotive Adhesion Promoter, thoroughly clean the surface of the hood scoop and scoop insert where adhesive tape will be applied. Using supplied Alcohol Prep Pads, thoroughly clean surface of hood where scoop will be applied.
    Caution:Do not use 3M Adhesion Promoter on vehicle’s painted surfaces.

    Painted Hood Scoop 0509 7

    Painted Hood Scoop 0509 8

  7. Apply the supplied adhesive tape to the scoop insert and the edges of the scoop, making sure it does not extend past the edges.

    Painted Hood Scoop 0509 9

    Painted Hood Scoop 0509 10

  8. Peel backing from adhesive tape on scoop insert and using guidance holes, apply it to the hood scoop.

    Painted Hood Scoop 0509 11

  9. Insert the supplied hardware into the 4 holes on the hood scoop and the 3 holes on the hood scoop insert.

    Painted Hood Scoop 0509 12

    Painted Hood Scoop 0509 13

  10. Peel backing from adhesive tape on hood scoop.

    Painted Hood Scoop 0509 14

  11. Carefully place hood scoop on top of hood making sure that all 7 bolts go through the holes you have drilled. Once all bolts are in, secure them with supplied nuts from underneath the hood.

    Painted Hood Scoop 0509 15

  12. After all nuts are secure, lower hood and push firmly on hood scoop where adhesive tape was applied to ensure a proper fit.

    Painted Hood Scoop 0509 16

  13. Raise hood and re-install hood insulation with clips that were removed in Step 4.

    Painted Hood Scoop 0509 17

Installation instructions provided by Stack Racing